UEN00660-00 50 Disassembly and assembly 15. Remove seal (14). Installation 1. Install front seal (14) using tool A1 . a Before installing the seal, check that the end corners and lip sliding surfaces of the crankshaft are free from flaw, burr, and rust of the housing. a When installing the seal, do not coat the shaft and seal lip with oil, grease etc. Also, wipe off grease from the shaft completely. a From cover (C) of seal (14) • Extrusion x : less than 0.38 mm • Facial run out (TIR: total indicator read- ing) y : less than 0.25 mm 12 PC210, 230, 240-8