UEN00660-00 50 Disassembly and assembly 16. Disconnect fuel return hose (15). 17. Disconnect bracket (16). [*6] 18. Remove fuel block (17). [*7] 10. Disconnect bracket (9). [*2] 11. Remove hose, tube and air intake connector assembly (10). [*3] a Remove it without separating from the bracket. a Mark the hose edge and tube to show the original hose installation positions. (See figure below.) 19. Disconnect connector (18). a Pull out connector (18) in the direction of the arrow while pushing up its lock with flat-head screwdriver [1]. 20. Disconnect connector (19). a As you cannot hold the connector, remove it as follows, using two flat-head screw- drivers.
1) Keep pushing the lock of connector (19) with flat-had screwdriver [1]. 2) Insert flat-head screwdriver [2] to the gap between the left or right side of the lock and the connector. Then twist the screw- driver from side to side gently to remove the connector gradually. 21. Disconnect connector with boost pressure and intake air temperature sensor (20). a Keep electrical intake air heater (H) drawn to the counterweight side. a Keep the harness drawn to the counter- weight side. [*8] 12. Disconnect radiator hose (11). [*4] 13. Disconnect heater hose (12). 14. Remove fan guard (13). 15. Disconnect fuel return hose (14). [*5] 18 PC210, 230, 240-8