Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Removal and installation of cylinder head assembly

50 Disassembly and assembly UEN00660-00 41. Disconnect clamp (42). 42. Disconnect connector with water temperature sensor (43) and air intake pressure sensor (44). a Connector with water temperature sensor (43) Pull the lock (female side) to the outside. a Air intake pressure sensor (44): 1) Push lock (L1) and slide it. 2) Pull out the connector while pushing lock (L2). 45. Remove head cover (48). 46. By cranking, align mark 1 (M1) at the damper side with mark 2 (M2) at the engine speed sen- sor side. a Be careful that the aligning position is not the 1st and 6th cylinder top position but the 3rd and 4th cylinder top position. a Mark 1 (M1) corresponds to wide-width slit (WS).

a Refer to the Adjusting of Valve Clearance section in the Testing and adjusting chap- ter of this manual. a Use tool A4 (refer to the tool list) for crank- ing. 43. Remove blow-by duct (45). 44. Disconnect fuel return tube (46). PC210, 230, 240-8 21