50 Disassembly and assembly UEN00660-00 Installation a Reference Inserted air hose length q Installation is done in the reverse order of removal. 3 Radiator hose clamp: 10.8 – 11.8 Nm {1.1 – 1.2 kgm} [*3] a Confirm that the heat insulating seal material (sponge) of the radiator peripheral part is not damaged. If the heat insulating seal material (sponge) is damaged, replace it to the new one. q 45 mm (Both upper and lower side) [*1] 1. Install hose and tube assembly (4). a Use brand new article for MIKALOR clamp. a Align the hose to the original position (marking position). a Inserted air hose length q Aftercooler side:
60 mm Confirm from the under cover side that convex- ity (A) of the radiator is correctly set to concav- ity (B). q Engine side A : 80 mm q Engine side B : 65 mm a Set bridge (BR) under the clamp tighten- ing bolt as the lap with band (BR) is Min.5mm. a Align the clamp to the original position. a Impact wrench is not applicable to use. q Refilling engine coolant Refill water through the water filler port up to the specified level. Start the engine and circu- late the water, and then check the water level. 5 Coolant: Approx. 21 l (PC210, 230) Approx. 20.4 l (PC240) 3 MIKALOR clamp:
16 – 17 Nm {1.6 – 1.7 kgm} a When the tightening torque force is less than 16Nm{1.6kgm}, tighten it until the hand gap is adhered (BDG size is 0). [*2] a Align the hose to the original position (marking position). a Align the clamp to the original position. PC210, 230, 240-8 31