50 Disassembly and assembly UEN00660-00 Removal and installation of engine and hydraulic pump assemblies 3. Remove cover (1). Special tools Removal k Disconnect the negative terminal (–) of the battery before starting the work. 4. Drain the engine cooling water. 6 Coolant: Approx. 21 l (PC210, 230) Approx. 20.4 l (PC240) k After lowering the work equipment to the ground completely and stopping the engine, release the internal pressure of the hydraulic tank by gradually loosening the cap of the hydraulic tank. a Attach an identification tag to each piping to avoid a mistake in the position of installation later. 5. Temporary sling engine hood (2).
a When slinging the engine hood, use care not to damage the rubber seal. 6. Remove pin (3) and (4), then remove two gas springs (5). 7. Lift off engine hood (2) to remove it. 1. Turn the upper structure by 90 degrees. 4 Engine hood: 50 kg 2. Remove hydraulic tank strainer and stop oil flow-out using tool A10, A11 . a If tool A10,A11 are not used, remove the drain plug and drain oil from the hydraulic tank and piping. 6 Hydraulic tank: Approx. 234 l (PC210, 230) Approx. 239 l (PC240) PC210, 230, 240-8 37 Symbol Part number Part name Necessity Q’ty N/R Sketch A 8 796T-401-1110 Plate q 1 N Q 9 795-790-9300 L ifting tool q 1 N 10 796-460-1210 Oil stopper q 1 11 796-770-1320 Adaptor q 1