UEN00660-00 50 Disassembly and assembly [*2] a Replace the O-ring to the new one. [*3] a Confirm that the heat insulating seal material (sponge) of the radiator peripheral part is not damaged. If the heat insulating seal material (sponge) is damaged, replace it to the new one. Removal and installation of fuel cooler assembly Removal a If the fuel is too much, drain the fuel in order to stop the fuel flow from the fuel tank return hose. 1. Disconnect fuel hose (1) and (2) with the pre- caution described below. a Be sure to disconnect the hoses in avoid- ing the input force to the cooler body by fixing elbow (L) with wrench (1).
a Be sure to use wrench [1], otherwise the force is loaded to the cooler body and the weld portion (M) may be separated. 2. Remove fuel cooler assembly (3). Confirm from the under cover side that convex- ity (A) of the radiator is correctly set to concav- ity (B). Installation q Installation is done in the reverse order of removal. 36 PC210, 230, 240-8