50 Disassembly and assembly UEN00660-00 Installation 8. Disconnect tube (6) from the lower side. [*2] 9. Move cover (7). a In order to avoid the contact with the flange. q Installation is done in the reverse order of removal. [*1] 1. Install hose and tube assembly (4). a Use brand new article for MIKALOR clamp. a Align the hose to the original position (marking position). a Inserted air hose length q Aftercooler side: 60 mm q Engine side A : 80 mm q Engine side B : 65 mm 10. Remove the mounting bolt and lift out radiator assembly (8). [*3] 4 Aftercooler assembly: 15 kg a Set bridge (BR) under the clamp tighten- ing bolt as the lap with band (BR) is Min.5mm.
a Align the clamp to the original position. a Impact wrench is not applicable to use. 3 Clamp: 16 – 18 Nm {1.6 – 1.8 kgm} a When the tightening torque force is less than 16 Nm {1.6 kgm}, tighten it until the hand gap is adhered (BDG size is 0). PC210, 230, 240-8 35