Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Removal and installation of final drive assembly

UEN00661-00 50 Disassembly and assembly Power train a PC210-8, PC210LC-8, PC210NLC-8 4. Temporarily hoist the final drive assembly (6). 5. Remove 18 mounting bolts (7) and hoist final drive assembly (6) to remove it. [*1] a Be careful so that the nipple sealing sur- face on the hose mounting block may not be damaged. Removal and installation of final drive assembly Removal 1. Remove the sprocket, refer to the Removing Sprocket section in this manual. 4 Final drive assembly: 300 kg k Completely lower the work equipment to the ground and stop the engine. Then loosen the oil filler cap for the hydraulic tank to release the pressure inside the tank. 2. Remove cover (1).

a PC230-8, PC240LC-8, PC240NLC-8 6. Temporarily hoist the final drive assembly (8). 7. Remove 18 mounting bolts and hoist final drive assembly (8) to remove it. [*2] a Be careful so that the nipple sealing sur- face on the hose mounting block may not be damaged. 4 Final drive assembly: 380 kg 3. Disconnect the travel speed selector hose (2), the motor hose (3), and the drain hose (5). 2 PC210, 230, 240-8