Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of final drive assembly

UEN00661-00 50 Disassembly and assembly Disassembly and assembly of final drive assembly a PC210-8, PC210LC-8, PC210NLC-8 4. Remove spacer (2). 5. No.1 carrier assembly 1) Remove No.1 carrier assembly (3). Special tools 2) Disassemble No. 1 carrier assembly as follows. 1] Insert pin (4) and drive shaft (5) out of carrier (6). a After removing the shaft, remove pin (4). 2] Remove thrust washer (7), gear (8), bearing (9), and thrust washer (10) from carrier (6). Disassembly 1. Oil draining Remove drain plug and drain oil from final drive case. 6 Final drive case: Approx. 3.5 l 2. Set the final drive assembly on the block [1]. 3. Remove mounting bolts to remove cover (1).

a When cover (1) is difficult to be separated, tap the cover (1) with a plastic hammer. 4 PC210, 230, 240-8 Symbol Part number Part name Necessity Q’ty N/R Sketch J 1 796-427-1400 Wrench assembly t 1 N 796-427-1410 • Wrench 1 N 796-427-1140 • Pin 3 01314-20612 • Screw 3 2 796T-427-1510 Push tool t 1 N Q 790-101-2510 Block t 1 790-101-3310 Block t 1 790-101-2610 Rod t 2 790-101-2730 Adaptor t 2 01580-11613 Nut t 2 790-101-2570 Plate t 2 01643-31645 Washer t 2 790-101-2102 Puller (30 t) t 1 790-101-1102 Pump t 1 3 796-427-1520 Installer t 1 N