Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of final drive assembly

50 Disassembly and assembly UEN00661-00 a PC210-8, PC210LC-8, PC210NLC-8 3. Use the tool J3 to install floating seal (31) to travel motor (29). a Install floating seal with the O-ring and O- ring contact surface de-greased and dried completely. a After installing the floating seal, check that the angle of the floating seal is within 1 mm. a After floating seal installation, apply a thin coat of power train oil ( TO30 ) on the slid- ing surfaces. Assembly a Clean the parts completely and inspect them for any foreign material or damage. Apply power train oil ( TO30 ) on the sliding surfaces before assembly. 1.

Hub assembly 1) Use push tool to press fit bearing outer races (27) and (28) into hub (32). 2) Use the tool J3 to install floating seal (30). a Install floating seal with the O-ring and O-ring contact surface de- greased and dried completely. a After installing the floating seal, check that the angle of the floating seal is within 1 mm. a After floating seal installation, apply a thin coat of power train oil ( TO30 ) on the sliding surfaces. 4. Set hub assembly (25) to travel motor. 5. Install bearing (26) by tapping it lightly with the push tool. 2. Install bearing (32) to travel motor (29). a Warm the inner race of the bearing (32) to 50 – 70 °C with heater. a Cool the bearing (32) down.

Tap the bear- ing (32) with a drift and listen to the sound to check that it is fully seated. PC210, 230, 240-8 7