Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of final drive assembly

UEN00661-00 50 Disassembly and assembly 6. Nut 1) Install nut as follows. 1] Rotate the hub 2-3 times. 2] Use the tool J2 and the push tool [5] to press the inner race of the bearing (26). a Pressing force: 29.4 – 38.2 kN {3.0 – 3.9 ton} 3] Rotate the hub to the both directions at least 5 times in total with the bear- ing inner race pressed. 4] Release the pressing force. 5] Press the bearing again. a Pressing force: 17.7 – 21.6 kN {1.8 – 2.2 ton} 6] Rotate the hub 2 – 3 times. 2) Measure the tangential force of the hub against the motor case in the rotation direction using the push scale [6]. a Tangential force:

490 N or less {50 kg or less} a The tangential force denotes the maximum force at start of the rotation. 7] Measure the size a under the condi- tion described in 6] above. 3) Install lock plate (23). a Install the lock plate so that the splines (A) of the lock plate and the motor are in full contact. 2 Mounting bolt thread: Adhesive (LT-2) a Do no apply the adhesive (LT-2) to the tapped portion of the nut. 8] Measure thickness off the inde- pendent nut (24). 9] Determine Calculate a – b = c 10] Use the tool J1 to tighten nut (24) until the following condition is met: size d: c +0.06/-0.04 8 PC210, 230, 240-8