Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of final drive assembly

50 Disassembly and assembly UEN00661-00 a After the pin is inserted, stake the pin (B) on the carrier. 7. No.2 carrier assembly 1) Assemble No. 2 carrier assembly as fol- lows. a Replace thrust washers (19) and (22) as well as pin (16) with new ones. a There are traces of expansion on the end surface of carrier side hole “e“ which were originally caused when the pin was inserted. Make such the end surfaces are smooth enough before reassembly. 1] Assemble bearing (21) to gear (20), fit top and bottom thrust washers (19) and (22) and then set the gear assembly on carrier (18).

2] Align the pin holes on the shaft (17) and the carrier, and install the shaft (17) by tapping it lightly with a plastic hammer. a Install the shaft, rotating the plan- etary gear. Take care so the thrust washer is not damaged. 2) Install No. 2 carrier assembly (14). a Align the 4 gear shaft ends of the car- rier assembly with the 4 dimples on the motor case end surface to install. 8. Thrust washer Install thrust washer (15). 3] Insert pin (16).

a When inserting the pin, take care so that any of the three pawls on the circumference (Portion f ) may not touch the thin-walled portion on the carrier (Portion g ).Take note, however, that the thin-walled portion is likely to be on the opposite side of the car- rier, depending on actual individ- ual items. Pay attention so that a pin pawl will not come to the slender side of the carrier any way.And when traces of the groove are present, assembly must be done avoiding such locations. a After assembling the carrier assembly, check that gear (20) rotates smoothly. PC210, 230, 240-8 9