UEN00661-00 50 Disassembly and assembly 9. No. 2 sun gear Install No. 2 sun gear (13). 10. No. 1 sun gear Install No. 1 sun gear (11). 11. Thrust washer Install thrust washer (12). 2] Align the pin holes on the shaft (5) and the carrier, and install the shaft (5) by tapping it lightly with a plastic hammer. a Install the shaft, rotating the plan- etary gear. Take care so the thrust washer is not damaged. 3] Insert pin (4).
a When inserting the pin, take care so that any of the three pawls on the circumference (Portion f ) may not touch the thin-walled portion on the carrier (Portion g ).Take note, however, that the thin-walled portion is likely to be on the opposite side of the car- rier, depending on actual individ- ual items. Pay attention so that a pin pawl will not come to the slender side of the carrier any way.And when traces of the groove are present, assembly must be done avoiding such locations. a After assembling the carrier assembly, check that gear (8) rotates smoothly. a After the pin is inserted, stake the pins (C) on the carrier at 2 loca- tions. 12. No.1 carrier assembly 1) Assemble No.
1 carrier assembly as fol- lows. a Replace thrust washers (7) and (10) and pin (4) with new ones. (Refer to Pin (4): 3].) a There are remains of caulking when the pin is inserted at the end face of hole “h“ at the side of the carrier. Remove the caulked metal from the inside diameter of the hole before starting to assemble. 1] Assemble bearings (8) and (9), fit top and bottom thrust washers (7) and (10) and then set the gear assembly on carrier (6). 10 PC210, 230, 240-8