Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Removal and installation of swing motor and swing machinery assembly

50 Disassembly and assembly UEN00661-00 10. Pull drain hose (16) out. 11. Disconnect pilot hose to cancel swing brake (17)(B port). Installation 12. Remove 12 pcs. of mounting bolt (18). [*1] q Installation is done in the reverse order of removal. [*1] 3 Mounting bolt: 490 – 608 Nm {50 – 62 kgm} q Refilling with oil (hydraulic tank) Refill hydraulic oil through the oil filler port to the specified level. Let the oil circulate in the hydraulic system by starting the engine. Then check the oil level again. q Air bleeding Bleed the air from the circuit between the valve and the hydraulic cylinder. For details, see Testing and adjusting, air bleeding of various parts. 13.

Lift and remove the swing motor and swing machinery Assembly (19). a Being careful not to damage hose (H), etc. with bar [1], lift the swing motor and swing machinery Assembly gradually and remove them. a Being very careful for the drain hose, lift them. a Lift them with full attention until surpass the hose of the center swivel joint. 4 Swing motor and swing machinery Assembly: 250 kg PC210, 230, 240-8 21