Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of swing motor and swing machinery assembly

50 Disassembly and assembly UEN00661-00 12. Shaft assembly 1) Using push tool [4], [5], remove shaft (26). 2) Remove bearing (27) and oil seal (29) from cover (28). 14. Remove bearing (31) from case (30). a Apply a suitable tool on the circumference of the outer race (thick line: Q section), strike the tool on the circumference with the hammer lightly, equally, by turns, and remove the bearing gradually. a If the outer race is made incline, bearing becomes hard, so remove it horizontally. a Only PC240LC-8, PC240NLC-8 13. Remove spacer (41) and O ring (42) from shaft (26). PC210, 230, 240-8 25