Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of swing motor and swing machinery assembly

UEN00661-00 50 Disassembly and assembly Assembly a Wash each part finely and check if there are not a garbage, a crack, etc., and apply power line oil to the sliding portion and assemble them. 2. Using push tool [9], press fit bearing (27) into case (30). a Use the new bearing. a The bearing and the oil seal, which were removed, are not re-used. New ones should be used. 1. Oil seal Using tool F3 , install oil seal (29) into cover (28). a Be careful for the direction of the oil seal (up and down). 2 Outside perimeter of oil seal: Gasket sealant (LG-6) a When press-fitting, take care so that gas- ket sealant (LG-6) will not stick to the lip surface of the oil seal. 3.

Install cover Assembly (33) into case Assem- bly (32). 2 Cover mounting face: Gasket sealant (LG-6) a Be careful not to adhere gasket sealant (LG-6) to drain port section (DP). a Align the drain process section of cover into the drain port section (DP). a If tool F3 is not used, use the push tool which can push outside perimeter section (A) of oil seal (29). a Be careful not to incline oil seal (29). 26 PC210, 230, 240-8