50 Disassembly and assembly UEN00661-00 a Just before oil seal (29) goes into shaft (B) part, case Assembly (32) is leveled so that case Assembly (32) may be located at the center of shaft (26), and be careful not to damage the oil seal lip part. 4. Shaft and case Assembly a 1) and 2) for PC240LC-8, PC240NLC-8 only. 1) Install O ring (42) into spacer (41). 2) Using push tool [16], press fit spacer (41) into shaft (26). a Be careful not to bite O ring (42). 3) Set case Assembly (32) into shaft (26). 2 Oil seal lip section: Grease (G2-LI) a Put case Assembly not to interfere the oil seal.
4) Using tool F1 , push tool [10], and hammer [11], strike inner race section of bearing (27) not to fall down the shaft. a Let lifting tool [12] be slacked. 5. Bearing Using tool F2 and push tool [15], press fit bear- ing (31). a When press-fitting the bearing, press both inner and outer races of the bearing at the same time. Avoid pressing the inner race only. q Input pin press (reference): Inner side 9.4 – 26.6 kN {960 – 2,710 kg} Outer side 0 – 8.9 kN {0 – 910 kg} a After the bearing is press-fitted, check that the case will turn freely. 5) Set into the press. 6) Using tool F1 , push tool [13], [14], press fit inner race section of bearing (27).
a Put in push tool [14] for the cases that the case Assembly is inclined a lot. a If case Assembly (32) is inclined, strike the flange section lightly and corrected it. PC210, 230, 240-8 27