UEN00661-00 50 Disassembly and assembly 4] Strike lightly with plastic hammer, etc., align pin hole location of shaft (17) and career and install shaft (17). a Install the shaft, rotating the plan- etary gear. Take care so the thrust washer is not damaged. 5] Insert pin (16), a As inserting the pin, install not to interfere claw section ( a section) which is in 3 places on circumfer- ence into career thin part ( b sec- tion). However, actual thing may have the thin section on the other side. So make sure to confirm the actual thing and assemble not to interfere claw section of the pin into the thin part. a After inserting the pin, caulk 2 parts of the career (c) around the pin hole. 6.
No.2 carrier assembly 1) Assemble No. 2 carrier assembly as fol- lows. a Since there is a mark to be caulked in the side hole h of career (18) at the time of pin insertion, remove climax for hole inner diameter beforehand. (Refer to 5]) 1] Incorporate plate (22) into career (18). 2] Incorporate bearing (21) and 2 pcs. of upper and lower thrust washer (19) into gear (20). 3] Set gear Assembly into career (18). a PC210-8, PC210LC-8, PC210NLC-8, PC230-8 2) Install No.2 career Assembly (15) with bolt (14). 2 Mounting bolt threaded section: Adhesive compound (LT-2) 3 mounting bolts: 157 – 196 Nm {16 – 20 kgm} 3) Install O ring (36) into case (30). a PC240LC-8, PC240NLC-8 28 PC210, 230, 240-8