Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Removal and installation of swing circle assembly

UEN00661-00 50 Disassembly and assembly Removal and installation of swing circle assembly q Installation is done in the reverse order of removal. Installation Removal 1. Disassemble the revolving frame assembly referring to the Disassembling Revolving Frame Assembly section in this manual. [*1] a Let the soft zone position S mark of an inner race: a and the soft zone position S mark of an outer race: b to be right side of the body as mentioned below and install it to the track frame. 2. Sling swing circle assembly (1) at three points and remove the mounting bolt to remove the assembly. [*1] 2 Amount of filled grease: Grease (G2-LI) 15.8 l 4 Swing circle Assembly:

300 kg 2 Swing circle mounting bolt threaded portion: Adhesive compound (LT-2) q In case of torque tightening: 3 Swing circle mounting bolt: 716 – 814 Nm {73 – 83 kgm} q In case of angle tightening: 3 Swing circle mounting bolt: 1) Initial torque: 294.2 ± 29.4 Nm {30 ± 3 kgm} 2) After that, rotate the bolt 60 ± 6 ° 32 PC210, 230, 240-8