Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of carrier roller

50 Disassembly and assembly UEN00662-00 6. Using push tools [2] and [3], remove bushing (8) from roller (4). Assembly 1. Using push tools [3] and [4], press fit bushing (8) to roller (4). a Press it from the side of cover (3) 2. floating seal 1) Using tool L1 , install floating seal (7) to roller (4). 2) Using tool L1 , install floating seal (6) to roller (5). a When installing the floating seal, completely wash and de-grease and dry both O-ring and the surfaces where the O-ring and the floating seal will contact each other (hatched in the sketch). And take care that there is no dust sticking on the contact surface of floating seal.

a When fitting the floating seal, use a tool L1 and be sure that the O-ring is pushed during the insertion. a After inserting the floating seal, verify that the inclination of the seal is less than 1 mm per its diameter and that the protrusion height of the seal shown as a in the illustration falls within the range of 7 – 11 mm. PC210, 230, 240-8 3