Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of carrier roller

UEN00662-00 50 Disassembly and assembly 3. Install roller (4) and ring (5) to shaft (2). a On the sliding surfaces of floating seals, apply some oil and take care not to have any dirt stuck on them. 6. Fill carrier roller assembly (1) with oil and tighten plug (9). 4. To make the height gap between roller (4) and ring (5) 1.8 ± 0.2 mm , put washer [7] between push tool [6] and roller (4), then press fit ring (5) to shaft (2). a The thickness of washer [7] is 1.8 ± 0.2 mm. a Use push tool [5] to support shaft (2) on it. 3 Plug: 15 ± 5 Nm {1.5 ± 0.5 kgm} 5 Carrier roller: 75 – 85cc (E030-CD) 5. Using push tool [8], press fit cover (3) to roller (4).

a De-grease, wash and dry the surfaces where roller (4) and cover (3) fit tight. q Press fitting force (reference): 59 kN {6,000 kg} Min 4 PC210, 230, 240-8