Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of track roller assembly

UEN00662-00 50 Disassembly and assembly 3. Using tool L2 , install floating seal (6a) to collar (8). a When installing the floating seal, com- pletely wash, de-grease and dry both O- ring and the surfaces of floating seal where they contact each other (shown hatched in the illustration). And take care that there is no dust sticking on the con- tact surfaces of floating seal. a After inserting the floating seal, verify that the inclination of the seal is less than 1 mm per its diameter and that the protru- sion height shown as a in the illustration falls within the range of 7 – 11 mm. 4. Using tool L2 , install floating seals (6b) and (3b) to roller (4).

a As to notes for installation of floating seals (6b) and (3b), refer to a marked com- ments in the section 3. 7. Using tool L2 , install floating seal (3a) to collar (2). a As to notes for installation of floating seal (3a), refer to a marked comments in the section 3. a On the sliding surfaces of the floating seals, apply some oil and take care not to have any dust stuck on them. 8. Fit an O-ring and install collar (2) to the shaft with pin (1). 9. Add oil and tighten the plug. 5 Amount of oil: 190 – 200 cc (E030-CD) 3 Plug: 15 ± 5 Nm {1.5 ± 0.5 kgm} 5. Install shaft (5) to roller (4). 6. Put roller (4) and shaft (5) assembly up side down. 6 PC210, 230, 240-8