UEN00662-00 50 Disassembly and assembly Assembly q Structural illustration 3. Using tool L3 , install floating seals (6) to idler (4) and to shaft (5) and support (7) assembly. a Completely wash, de-grease and dry both O-rings and the surfaces (shown hatched in the illustration) of floating seals where they contact each other. a Coat the sliding surface of the floating seal with oil, and be careful not to let any dirt or dust get stuck to it. a After inserting the floating seal, verify that the inclination of the seal is less than 1 mm per its diameter and that the protru- sion height shown as a in the illustration falls within the range of 7 – 11 mm. 1.
Press fit bushings (9) and (10) to idler (4). 2. Fit an O-ring and install support (7) to shaft (5) with dowel pin (8). 8 PC210, 230, 240-8