50 Disassembly and assembly UEN00662-00 4. Assemble shaft (5) and support (7) assembly to idler (4). 6. Fit an O-ring and install support (2) to the shaft with dowel pin (1). a See structual illustration. 7. Add oil and tighten the plug. 5 Amount of oil: 245 – 255 cc (E030-CD) 3 Plug: 205.8 ± 49 Nm {21 ± 5 kgm} 5. Using tool L3 , install floating seals (3) to idler (4) and to support (2). a Completely wash, de-grease and dry both O-rings and the surfaces (shown hatched in the illustration) of floating seals where they contact each other. a Coat the sliding surface of the floating seal with oil, and be careful not to let any dirt or dust get stuck to it.
a After inserting the floating seal, verify that the inclination of the seal is less than 1 mm per its diameter and that the protru- sion height shown as a in the illustration falls within the range of 7 – 11 mm. PC210, 230, 240-8 9