UEN00662-00 50 Disassembly and assembly Disassembly and assembly of recoil spring 1. Remove piston assembly (2) from recoil spring assembly (1). Special tools 2. Disassembly of recoil spring assembly 1) Set tool M1 to recoil spring assembly (1) k Since the recoil spring will be pressed to a high installation load, be very sure to set the tool prop- erly to prevent any risk. a Installation load 137.3kN {14,010 kg} 2) Apply hydraulic pressure gradually to remove lock plate (3) then nut (4). a Compress the spring up to the point where the nut gets loose. a Release the hydraulic pressure slowly and release the tension of the spring.
a Free length of spring 556 mm 3) Remove yoke (6) and cylinder (7) from spring (5). 4) Remove snap ring (8), dust seal (9) and bushing (10), one after the other, from cyl- inder (7). Disassembly q Structural illustration 3. Further disassembly of piston assembly(2) 1) Remove lock plate (12) from piston (11), and then valve (13). 2) Remove snap ring (14), and then U-pack- ing (15) and ring (16).
10 PC210, 230, 240-8 Symbol Part number Part name Necessity Q’ty N/R Sketch M 1 791-600-2001 C or 791-685-8006 C ompressor (A) ompressor (B) t 1 t 1 790-201-2780 S pacer 791-635-3160 E xtension t 1 C 790-101-1600 (6 ylinder 86kN{70ton}) t 1 790-101-1102 P ump t 1 790-640-2180 G P uide bolt ush tool t 1 2 790-101-5201 ki • 790-101-5241 • t (B) Plate q 1 1 • 790-101-5221 • Grip 1 • 01010-51225 • Bolt 2 3 P 790-201-1500 ki ush tool t q 1 • 790-201-1620 • Plate 1 • 790-101-5021 • Grip 1 • 01010-50816 • Bolt 1