Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Removal and installation of center swivel joint assembly

UEN00663-00 50 Disassembly and assembly Hydraulic system 4. Disconnect eight hoses (7) through (14). q (7): Center swivel joint (E port) – L.H travel motor (P port) Removal and installation of center swivel joint assembly q (8): Center swivel joint (E port) – R.H travel motor (P port) q (9): Center swivel joint (D port) – Swing motor (T port) Removal k Lower the work equipment to the ground completely, after the engine is stopped, loosen the hydraulic tank cap gradually to reduce the pressure inside, and set the lock lever in the lock position. a Attach an identification tag to each piping to avoid a mistake in the position of installation later. q (10):

Center swivel joint (E port) – solenoid valve q (11): Center swivel joint (B port) – L.H. travel control valve (A2 port) q (12): Center swivel joint (D port) – R.H. travel control valve (B5 port) q (13): Center swivel joint (A port) – L.H. travel control valve (B2 port) q (14): Center swivel joint (C port) – R.H. travel control valve (A5 port) 1. Swing to right 45 degree. (For hydraulic tank oil drain) a For the way not to drain the hydraulic tank oil by using oil stopper, see Removal and installation of hydraulic pump assembly. 2. Drain hydraulic tank oil. 5. Pull out pin (15) on the center swivel joint side, and remove the jam plate from center swivel joint. 6 Hydraulic tank: Approx.

234 l (PC210, 230) Approx. 239 l (PC240) 3. Disconnect six center swivel joint horses (1) through (6) from the travel motor. q (1): Center swivel joint (T port) – L.H. travel motor (T port) q (2): Center swivel joint (T port) – R.H. travel motor (T port) q (3): Center swivel joint (B port) – L.H travel motor (PA port) q (4): Center swivel joint (D port) – R.H travel motor (PB port) q (5): Center swivel joint (A port) – L.H travel motor (PB port) q (6): Center swivel joint (C port) – R.H travel motor (PA port) 2 PC210, 230, 240-8