Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Removal and installation of hydraulic tank assembly

50 Disassembly and assembly UEN00663-00 Installation 15. Remove six mounting bolts (21). [*3] q Installation is done in the reverse order of removal. [*1] 3 Hydraulic tank drain plug: 58.8 – 78.5 Nm {6.0 – 8.0 kgm} [*2] a Use brand new article for MIKALOR clamp. a Align the hose to the original position (marking position). a Reference Hose insertion length:85mm (L.H and R.H) 16. Lift off hydraulic tank assembly (22) to remove it. 4 Hydraulic tank assembly: 130 kg a Set bridge (BR) under the clamp tighten- ing bolt as the lap with band (BR) is Min.5mm. a Align the clamp to the original position. 3 Clamp: 20 – 22 Nm {2.0 – 2.2 kgm} a Impact wrench is not applicable to use.

a When the tightening torque force is less than 16 Nm {1.6 kgm}, tighten it until the hand gap is adhered (BDG size is 0). [*3] 3 Mounting bolt: 245 – 309 Nm {25 – 31.5 kgm} q Refilling with oil (hydraulic tank) Refill hydraulic oil through the oil filler port to the specified level. Let the oil circulate in the hydraulic system by starting the engine. Then check the oil level again. 5 Hydraulic tank: Approx. 234 l (PC210, 230) Approx. 239 l (PC240) q Air bleeding Bleed the air from the circuit between the valve and the hydraulic cylinder. For details, see Testing and adjusting, air bleeding of various parts. PC210, 230, 240-8 7