UEN00663-00 50 Disassembly and assembly Removal and installation of control valve assembly 5. Disconnect clamp (10). 6. Keep away solenoid assembly (11) from con- trol valve bracket (B). k Release the remaining pressure in the hydraulic circuit. For details, see Testing and adjusting, release of remaining pres- sure in hydraulic circuit. Removal a Attach an identification tag to each piping to avoid a mistake in the position of installation later. 1. Remove cover (1). 7. See Removal and installation of engine and oil pressure pump assembly to remove below.
q Engine hood q Control valve upper cover q Cover between hydraulic pump and en- gine q Flame between control valve and engine q Cover between control valve and engine 8. Disconnect PLS1 port hose (12). a Hose band: No color 9. Disconnect PLS2 port hose (13). a Hose band: red 2. Drain hydraulic tank oil. a Make the swing speed almost 0 degree for below (3. – 6.) and to remove the control valve mounting bolt. 6 Hydraulic tank: Approx. 234 l (PC210, 230) Approx. 239 l (PC240) a For the way not to drain the hydraulic tank oil by using oil stopper, see Removal and installation of hydraulic pump assembly. 3. Disconnect drain hose (2) through (8). Band: q (2): No color q (3): Red q (4):
No color q (5): No color q (6): Red and yellow q (7): Brown q (8): No color 4. Disconnect connector (9) from clip. From the top, V06 V05 V04 V03 V02 V01 8 PC210, 230, 240-8