50 Disassembly and assembly UEN00663-00 Removal and installation of hydraulic pump assembly 3. Remove cover (1). Special tools Removal k Disconnect the negative terminal (–) of the battery before starting the work. k Lower the work equipment to the ground completely, after the engine is stopped, loosen the hydraulic tank cap gradually to reduce the pressure inside, and set the lock lever in the lock position. a Attach an identification tag to each piping to avoid a mistake in the position of installation later. 4. Temporary sling engine hood (2). a When slinging the engine hood, use care not to damage the rubber seal. 5. Remove pin (3) and (4), then remove two gas springs (5). 6.
Lift off engine hood (2) to remove it. a Attach an identification tag to each piping to avoid a mistake in the position of installation later. 1. Swing to right 45 degree. (For hydraulic tank oil drain) 2. Remove hydraulic tank strainer and stop oil flow-out using tool A10, A11 . a If tool A10,A11 are not used, remove the drain plug and drain oil from the hydraulic tank and piping. 7. Remove cover (7). 6 Hydraulic tank: Approx. 234 l (PC210, 230) Approx. 239 l (PC240) PC210, 230, 240-8 17 Symbol Part number Part name Necessity Q’ty N/R Sketch A 10 796-460-1210 Oil stopper q 1 11 796-770-1320 Adaptor q 1