Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of control valve assembly

UEN00663-00 50 Disassembly and assembly q Upper and lower control valve cover 2 Mating face of upper and lower control valve cover block (SE): SEALEND 242 or equivalent q Tighten the mounting bolts for the upper and lower control valve cover in order of fig- ure.(A o D o C o B) 3 Mounting bolt for upper and lower control covers: 156.9 – 176.5 Nm {16 – 18 kgm} q Pump merge-divider valve 2 Mating faces of merge-divider valve (SE2): SEALEND 242 or equivalent q Tighten the mounting bolts for the merge- divider valve in the same sequence as that for the control valve cover mounting bolts. 3 Merge-divider valve mounting bolt:

156.9 – 176.5 Nm {16 – 18 kgm} q Tighten back pressure valve, boom lock valve, arm quick return valve, arm check valve and mounting bolts in the same order as that for the control valve cover. 3 Back pressure valve, boom lock valve, arm quick return valve, arm check valve mount- ing bolt: 58.8 – 73.6 Nm {6 – 7 kgm} q After assembling, put a stopper (CAP) so that not to flow into oil and detergent liquid from ш12 hole. q Pressure compensation valve a Install each pressure compensation valve, paying attention to the counter mark that was put when removing it. Especially, do not install BKC1 and BKC2 adversely.

q Main relief valve assembly After assembling the main relief valve assembly in the control valve, refer to the section of Inspection and Adjustment of Hydraulic Oil Pressure in Hydraulic Circuit for Work Equipment, Swing and Travel in the chapter, Testing and adjust- ing, in this manual. 16 PC210, 230, 240-8