50 Disassembly and assembly UEN00663-00 Assembly of Control Valve Assembly q Coat the sliding surface with engine oil and then reassemble the control valve assembly. q When assemble spool (7) and (8) to the valve chamber, turn drill hole (H1) and (H2) to the direction as the diagram. a In the same way for section H-H,K-K,L-L,M-M. q Filter (13) installed on the bottom of PLS1 PORT and PLS2 PORT is to be assembled in the direction shown in the diagram below. (Be careful on *caulking section.) PC210, 230, 240-8 15