Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of control valve assembly

UEN00663-00 50 Disassembly and assembly 4. Likewise, set tool T3 to piston (2) in the same direction and push it slowly by hand so that another seal (6) may be spread out evenly. a The seal may be also fitted by pushing it down to the flat surface of the tool and then pushing it in with the tool fitted to the piston. 5. Keep compensation tool T4 fitted to piston (2) for about one minutes so that seal (5) and (6) are adapted well. a Check that there is no protrusion or cut on the seal. 6. Assemble the piston in the sleeve.

a If it is found difficult to install the piston, do not attempt to push it in forcibly, but set it to compensation tool T4 again and install the piston to the sleeve after adapting the seal. 7. Fit plug (3) and spring (4) to piston (2), then assemble pressure compensation valve (1). a After the installation, push the piston by hand and check that the piston reacts only with spring force. 14 PC210, 230, 240-8