Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of control valve assembly

50 Disassembly and assembly UEN00663-00 Disassembly and assembly of control valve assembly Procedures for replacing pressure compensa- tion valve seal a Since there are many types of pressure com- pensation valve, mark the positions when removing to correspond to the original. 1. Remove piston (2), plug (3) and spring (4) from pressure compensation valve (1). a This section deals with only precautions to be followed when reassembling the control valve assembly. Special tools 2. Remove piston (2) from seal (5) and (6). a There are many types of piston. 3. Set tool T2 to piston (2) and push it in slowly by hand so that seal (5) may spread out evenly.

a The seal may be also fitted by pushing it down to the flat surface of the tool and then pushing it in with the tool fitted to the piston.

PC210, 230, 240-8 13 Symbol Part number Part name Necessity Q’ty N/R Sketch T 2 796-946-1310 Guide ø21.8 t 1 (For 723-46-40100) 796-946-1610 Guide ø21.4 (For 723-46-41100) t 1 796-946-1810 Guide ø21.2 t 1 (For 723-46-43100 and 723-46-43400) 796-946-1910 Guide ø21.0 t 1 (For 723-46-46101 and 723-46-46300) 796-946-2210 Guide ø21.6 t 1 (For 723-46-45100 and 723-46-45700) 3 796-946-1320 Guide ø21.8 t 1 (For 723-46-40100) 796-946-1620 Guide ø21.4 t 1 (For 723-46-41100) 796-946-1820 Guide ø21.2 t 1 (For 723-46-43100 and 723-46-43400) 796-946-1920 Guide ø21.0 t 1 (For 723-46-46101 and 723-46-46300) 796-946-2220 Guide ø21.6 t 1 (For 723-46-45100) 796-946-1420 Guide ø21.6 t 1 (For 723-46-42700) 4 796-946-1330 Sleeve t 1 (For 723-46-40100) 796-946-1630 Sleeve t 1 (For 723-46-41100) 796-946-1830 Sleeve t 1 (For 723-46-43100 and 723-46-43400) 796-946-1930 Sleeve t 1 (For 723-46-46101 and 723-46-46300) 796-946-2230 Sleeve t 1 (For 723-46-45100) 796-946-1430 Sleeve t 1 (For 723-46-42700)