Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of travel PPC valve assembly

UEN00663-00 50 Disassembly and assembly Disassembly and assembly of travel PPC valve assembly a This chapter deals only with precautions to be followed when assembling the travel PPC valve assembly. Assembly a When assembling, clean and inspect the parts closely and take care fully so that dirt, rush, flaw, etc. never cause a trouble. 1. When assembling piston (1), apply grease (G2-LI) to its outside and inside of the body hole. 2. Install spring (2) with its small diameter side of the end coil diameter on the shim (3) side. q End coil diameter of the spring (inside diameter) Small diameter end: ш4.9 large diameter end: ш5.55 3.

Do not drive in bushing (4) by hitting it directly with a hammer. 4. Do not drive in pin (5) by hitting it directly with a hammer. 5. Apply grease (G2-LI) to the swaying part of shaft (6), the contact surfaces of lever (7) and piston (1), contact surfaces of damper (9) lever and pin (8). 2 Applying quantity of grease (G2-LI) Swing part of shaft (6): 4 – 8cc/all-around Contact surface of lever (7) and piston (1): 0.3 – 0.8cc/1 place Contact surface of damper (9) lever and pin (8): 0.3 – 0.8cc/1 place 6. Install washer (10) 1.6 mm thick first. If the dif- ference between both sides at the stroke and of the lever exceeds 0.7°, change the washer thickness to reduce the difference to below 0.7°.

(If the washer thickness is reduced by 0.3 mm, the stroke end angle is increased by 0.39°.) q Thickness of washers=1.0, 1.3, 1.6 7. Tighten each part to the following torque. q Plug (11): 34 – 44 Nm {3.5 – 4.5 kgm} q Plug (12): 9.8 – 14.7 Nm {1 – 1.5 kgm} q Plug (13): 24.5 – 34.3 Nm {2.5 – 3.5 kgm} q Bolt (14): 19.6 – 27.4 Nm {2.0 – 2.8 kgm} q Screw (15): 0.441 – 0.588 Nm {0.045 – 0.06 kgm} q Bolt (16): 25 – 31 Nm {2.5 – 3.2 kgm} q Bolt (17): 27 – 34 Nm {2.8 – 3.5 kgm} q Plug (18): 6 – 11 Nm {0.6 – 1.1 kgm} q Plug (19): 4 – 9 Nm {0.4 – 0.9 kgm} 24 PC210, 230, 240-8