Installation Installation Overview This section covers the single engine, marine gear (inboard) and stern drive installation. Power Wiring and System Diagrams are shown on pages 10 through 14. The tasks that must be completed to hook up the BY Unlimited Control Systems are as follows (This section takes you through each task area). 1. Install the engine. 2. Install battery switch and engine breaker. 3. Route the CE504XX Boat Harness from the engine area to the helm. 4. Install the CE50206 Engine Harness and make the various connections to that harness. 5. Install the Helm Components (mount per templates on pages 25 through 41). 6. Connect the CE50100 Helm Harness. 7.
Configure the Engine (if installing Marine Gear, proceed to Step 10). 8. Install the Stern Drive Actuator. 9. Calibrate the Stern Drive Shift Actuator. 10. Check out the Installation. WARNING Make all connections in accordance with applicable codes and standards. STEP 1 - Install the Engine. Install and align the engine per Yanmar’s Installation Manual, Volume 3 for BY Engines. If this is a Stern Drive installation, install the Stern Drive first, followed by the engine. Electronic Control System: Single Engine Installation Manual for BY Series Engines with Unlimited Controls Page © Yanmar 2008