NMEA 2000 ® CANBus Cables CM100XX: Cable CM10051: male terminator / CM10052: female terminator / CM10055: Deutsch terminator “T” Connector: Supplied by several vendors under part numbers CM10050 and CM10060. Appearance may vary - parts are interchangeable. Backbone Male Female NODE is always Female Note regarding connectivity of “T” Connectors: When connecting a “T” connector to a component (for example, i8130 module) always install via the middle connection (“NODE”). When connecting a “T” connector to a CANBus cable (for example, CM10703) to connect components that are far from each other, always install via the male/female end of the connector (whichever applies).
Hand-tighten after the connection is made. Do not tightly tie down the “T” connectors, as this will create stress and can cause damage. Electronic Control System: Single Engine Installation Manual for BY Series Engines with Unlimited Controls © Yanmar 2008 Page