Yanmar — Yanmar BY Series Electronic Control System Installation Manual

Installation Step 4 - Install the CE50206 Engine Harness. Engine Room Layout: Mount an i8130/40 module. The six foot length of CE50206 harness determines the maximum distance between the engine/transmission and the i8130/40 module. While the i8130/40 can be mounted horizontally or vertically, the preferred mounting is vertical with the connectors facing down. Mounting the i8130/40 Engine Interface: 1. Always mount the i8130/40 to a solid surface, but not directly to the engine. 2. Allow 4” cable clearance at the connections. i8130/40 Engine Interface Connecting the CE50206 Engine Harness: 1. Connect the J1 Connector of the CE50206 Engine Harness to the Engine as shown. NOTE:

Do NOT bend connector pins! Locate the Index Tab on the engine end connection of the CE50206 for correct orientation and be sure pins are properly in their sockets before rotating the Lock Ring. 2. Connect the P1 plug to the CE504XX Engine Harness, installed in “Step 3.” 3. Connect the J2 connector of the CE50206 to the i8130/40 Engine Interface. 4. For Marine Gear applications: Check to see if a CM10055 Terminator is 1. (also see diagram below) installed in the J7 NMEA Connector. If none is present, locate one in the kit and install. For Stern Drive applications see “Step 8.” 5. Tie back the J8 Diagnostic Connector (K Line). 6.

Connect the Fuel 1 and 2 and the Fuel 1 and 2 Returns to the appropriate senders in the fuel tanks (see Appendix H for details). 7. Connect the Paddle Wheel “REF,” “SIG,” and “GRD” connectors (See Appendix H for details). 8. For Marine Gear applications: tie back the Gear Lube and Gear Lube Return and Trim and Trim Return. For Stern Drive applications: connect the Gear Lube and Gear Lube Return to the Gear Lube Bottle. Connect the Trim and Trim Return to the Stern Drive. 9. For Marine Gear applications: connect the “Gear” to the Transmission Harness (see Appendix E or H for details). 1. to engine 2. CE504XX 4. CM10055 7. 5. 6. 3. 8. Electronic Control System:

Single Engine Installation Manual for BY Series Engines with Unlimited Controls Page 16 © Yanmar 2008