Installation STEP 5 - Install the Helm Components. 1. Mount the CP19500 Key Switch Panel using the template on page 33. Note: Allow 3.5 inches (88.9mm) behind the back of the CP19500 Key Switch Panel when mounting. 2. Mount the Control Head using the template on page 25 or the template that comes with the Control. 3. Connect the CH67600 Control Module using directions on page 19. Mount per template on page 27. 4. If Trolling Option is specified, mount the CP67601 Trolling Switch using a 16 mm or 5/8 inch hole. 5. Mount the i5601E Digital Display using the template on page 29 or page 31, depending on whether a front 6.
Mount any optional gauges that are specified, using the templates on pages 35, 37 and 39 accordingly or see or rear mount installation is required. Appendix I. 1. CP19500 Key Switch Panel 2. CH64600 Control Head 3. CH67600 Control Module 3. CP67601 Trolling Switch (optional) 5. i5601E Digital Display (optional) 6. 780757SDFB Digital Tachometer (optional) Electronic Control System: Single Engine Installation Manual for BY Series Engines with Unlimited Controls © Yanmar 2008 Page 17