Installation Connect the Control Head 1. Connect the Control Head cable to the appropriate end of cable harness CE42100 (big grey connector). 2. Connect the GREY connector on cable harness CE42100 to the GREY port on the CH67600 module. 3. Connect the BLACK connector on cable harness CE42100 to the BLACK port on the CH67600 module. 4 Install a CANBus “T” connector to the CANBus end of the CE42100 cable. Connect at the NODE. 5. Connect the “T” to the previously run CM10703 CANBus cable. 6. Terminate the “T” end with the appropriate gender CANBus Terminator. CH64600 Single Engine Control Head CH67600 2. 3. CE42100 optional trolling wires (see Appendix F) 1. Control Head 4. cable 6.
i5601e (optional) 5. CM10703 CANBus Connection Trolling Switch and Connection Diagram Trolling Switch Trolling Switch Connection Female Bullet small (.156 Dia.) Red - Switch Brown – LED Black – Switch/LED common Electronic Control System: Single Engine Installation Manual for BY Series Engines with Unlimited Controls © Yanmar 2008 Page 19