Appendix F Trolling Option Trolling Calibration All Trolling systems require set-up prior to initial use. The transmission MUST be fully warmed up and at normal operating temperature prior to calibration. Proper set-up calibration can only be achieved when the boat maneuvers are caused by the action of the propeller. Setting calibration during windy, strong current or rough water conditions may not result in the most favorable calibration. CAUTION: Trolling engagement should be performed only during safe conditions. Calibrating Trolling Go to the Digital Display and hold the right most key down until the Main Menu appears (about 5 seconds).
Using the below information navigate the menu down to Trolling Calibration. Performs the function indicated by a pop-up menu, if present. With no pop-up menu showing, briefly press to display the Lighting & Contrast menu. With no pop-up menu showing, press and HOLD to display the MAIN MENU. MAIN MENU ALARMs / DIAGs MONITOR SETTINGS CALIBRATION FACTORY SETTINGS Password Protected CALIBRATION USER SETTINGS TROLLING SHIFT ACTUATOR TROLLING Troll Mode SPLIT Lever 40 % Max Throttle 50 % VALVE CAL Electronic Control System: Single Engine Installation Manual for BY Series Engines with Unlimited Controls Page 66 © Yanmar 2008