Appendix F Trolling Option With the engine and transmission fully warmed up and in neutral idle record the LOAD value. This will typically be a number around 0%. Then put the boat in forward idle and record the LOAD value. A number between 5% and 15% is typical - however the numbers may vary quite a bit at the lower values. Record the SOG speed as well. Retain these numbers for later use. Return to neutral. Note: When making changes to the settings, allow sufficient time for the boat to respond. 1. Enter Troll Mode by placing the control lever at Neutral and pressing the separate trolling switch. “Down” Arrow moves menu selection down. “Up” Arrow moves menu selection up.
“Back” to previous menu. “Right” Arrow acts on current menu item. It will change the 3rd and 4th buttons to Plus and Minus keys to allow incremental 1% changes to the value. Caution: The boat will respond immediately as soon as a value is sent to the controller for each change. 2. Place the control lever in the forward idle position. The transmission will enter forward gear and the boat will move at “Forward Idle” speed. Select the Min Prop RPM on the digital display and using the “+” and “-” keys to adjust the value until the boat slows to minimum trolling speed. This resulting Min Prop RPM number varies by quite a bit so no typical number can be offered.
A 30-to-50% number is common on some transmissions. 3. Select the Max Prop RPM on the digital display and use the “+” and “-” keys to set the value such that the LOAD reading is about 2% lower than it was in the earlier recorded forward idle position. You want the boat to move forward just below normal idle speed. Calibration Notes If, after using troll, you determine that when you first enter forward idle in the troll mode the shaft is spinning too fast, you can go into the trolling calibration on the digital display menu and lower the Min Prop RPM value. If the shaft is spinning too slowly or not at all you can increase the Min Prop RPM value.
If, after using troll, you determine that the maximum trolling speed is too low, you can go into the trolling calibration on the digital display and raise the Max Prop RPM value. If the trolling max speed is too high, reduce the value of the Max Prop RPM. On some occasions the minimum value may be too low for the valve to operate. If lowering the value does not slow down the prop speed, try increasing the value until the prop responds and then adjust accordingly. Electronic Control System: Single Engine Installation Manual for BY Series Engines with Unlimited Controls © Yanmar 2008 Page 67