Komatsu — ACCUMULATOR

. OPERATION DETAILED CONTROLS AND GAUGES ACCUMULATOR WARNING 3 - 57 The accumulator is charg ed with high-pressure nitrogen g as, imprope r operation may cause an exp losion which could lead to serious injury or damage . When handling the accumulator, always do as follows: Pressure in the contro l circuit cannot be completely rem oved. Whe n removing the hydraulic equi pment, do not stand in the direction that oil spurt s out when performing the operati Loosen the bolts slow Do not disassemble th Do not bring it near fla Do not make holes in i Do not hit it, roll it, or When disposing of the accumulator, the gas must be rel eased.

Con tact your Komatsu distributor This machine is equipp edwith an accumulatorin the c ontrol circ uit. The accumulatoris a de vice to store oil pressure for the control circuit. Because an accumulator is ins talled, the control circuit can be actua ted for a short time even after the engine is stop ped. As a result, if the contro l lever is m oved in the LOWER directi on, the work equipment will go down under its The accumulator is ins talled to the position shown in the diagr on the right. Releasing Hydraulic Pressure with Accumulat 1. Place the work eq 2. Stop the engine. 3. Turn the key in sta 4. Move lock lever to strokes back and f 5. Move the lock leve 6. Turn the key in sta 1.

Place the work eq uipment on the ground. Close the crushe 2. Stop the engine. 3. Turn the key in sta rting switch to the ON position 4. Move lock lever to the free position. Move the wo rk equipm ent control lever and attach ment control pedal to full orth, right and left to release p ressure in the control circuit. 5. Move the lock leve r to the LOCK position. Lock t he control lever and attachment contr 6. Turn the key in sta rting switch to the OFF positio