. OPERATION TRANSPORTATION LOADING AND UNLOADING WITH TRAILER WARNING Always turn the auto-deceleration switch OFF (cancel) during loading and unloading operations. If the auto-deceleration switch is left ON, the machine may suddenly 3 - 110 When loading or unloadin speed. Do not operate th Run the engine at low idl slowly when loading or un g the machine on a trailer, always travel at low e travel speed selector switch. e, set to Lo speed, and operate the machine loading. Do not carry out loading o r unloading operations during th e automatic warming-up operation. If the automatic warming- up operation is canceled before completion, the travel speed may sudd enly change.
when loading or unloading the machine. rom the edge of the road. Select firm, level ground when loading or unloading the m achine. Maintain a safe distance f Use ramps with ample wid th, length, thickness, and strengt h and in stall them at a maximum slope of 15°. When using piled soil, com pact the piled soil fully and preve nt the s lope face from collapsing. Remove all mud and dirt from the machine tracks before starting in ine from slipping on the ramps. order to prevent the mach ine from slipping on the ramps. Be sure that the ramp surf ace is clean and free of water, sn ow, grease, oil, or ice. Never correct your steeri ng on the ramps. There is a hazard that the machine may turn over.
If necessary, drive off the ramps, correct the direction, th en ente r the ramps again. It is dangerous to use the work equipment for loading an d unloading operations. t operate any lever except the travel lever. When on the ramps, do no t operate any lever except the tr avel lev The center of gravity of th e machine will change suddenly at the joint between the ramps and th e track or trailer, and there is a h azard o f the machine losing its balanc e. Travel slowly over this point. When swinging the upper structure on the trailer, the trailer is unstable, pull in the work equipmen t and swing slowly. When loading or unloadin g, always use ramps or a pla tform. Proceed as