. OPERATION TROUBLES AND ACTIONS or 3 - 130 9. Push in the knob of pr iming pump (2) and tighte 10. Turn the key in the st arting switch to the STAR T position an d start the engine. When doing this, do n ot crank the starting motor continuousl y for more than 20 seconds . If th e engine d oes no start, wait for at least 2 minutes, then try again. Perform thi s operation a maxi mum of 4 time 11. If the engine does not start, repeat the operatio n from Step PHENOMENA THAT ARE NOT FAILURES Note that the following ph enomena are not failures:
When the arm control le ver is operated to the IN p osition and th work equipment is low ered under no load from a high positio the arm speed will dro less at the vertical posi When the bucket contr ol lever is operated to the CURL positio and the work equipme position, the bucket s nt is lowered under no loa d fro m a hig peed will drop momenta rily w hen th . bucket teeth are more or less at the horizontal po sition The bucket or arm wi digging operations. ll fluctuate by itself during heavy-du When starting or stopp ing the swing, noise will b e emitted fro m the brake valve. When going down a st eep slope at low speed, a noise will be emitted from the t ravel mo tor brake valve.