Komatsu — DISCHARGED BATTERY

. OPERATION TROUBLES AND ACTIONS Starting the Engine WARNING 3 - 136 Booster Cable Connection of the normal machine and problem ion. Keep the starting switch machine in the OFF posit Connect the booster cabl e as follows, in the order o f the n umbers marked in the diagram. booster cable (A) to the positive (+) m machine. of booster cable (A) to the positive (+) machine. booster cable (B) to the negative (-) machine. lip of booster cable (B) to the upper problem machine. 1. 2. 3. 4. 1. Connect one clip of terminal of the proble 2. Connect the other clip terminal of the normal 3. Connect one clip of terminal of the normal 4. Connect the other c structure frame of the X: Battery on normal Y:

Battery on problem Z: Upper structure fra Always check that the lock le ver is set to the LOCK position , regardless of whether the machine is working normally o r ha s failed. Check also that all the contro l levers are in the HOLD or n eutral p osition. 1. Make sure the clips a re firmly connected to the battery terminals . 2. Start engine of the no rmal machine and run it at high i dle s peed. 3. Turn the starting switc h of the problem machine to the START position and start the engine If the engine doesn't s tart at first, try again after 2 minutes or so. Booster Cable Disconnect ion rted, disconnect booster cables in the y were connected.

After the engine has sta reverse order in which the 1. 2. 3. 4. 1. Remove one clip of bo oster cable (B) from the re volvin g frame of the problem machi ne. 2. Remove the other clip of booster cable (B) from t he negative (-) terminal of the normal machine. booster cable (A) from the positive (+) machine. 3. Remove one clip of terminal of the normal 4. Remove the other clip of booster cable (A) from t he positive (+) terminal of the proble m machine. X: Battery on normal Y: Battery on problem Z: Upper structure fra