Komatsu — HANDLING OIL, FUEL, COOLANT, AND PERFORMING OIL CLINIC

. MAINTENANCE OUTLINE OF SERVICE the coolant. 4 - 5 Cooling System C River water contai ns large amount of calcium an d other impurities, s o if it is used, sca le will stic k to th e engine and radiator, and this will cause defective heat exch ange and overhea Do not use water t hat is not suitable for drinking When using antifr eeze, always observe the pre cautions given in th e Operation and Maintenance Manu Komatsu machine s are supplied with Komatsu original anti-freeze in the coolant w hen the m achin e is s hipped. This anti-freeze is effective in preventing corros ion of the cooling s ystem. The anti-freeze ca n be used continuously for tw o years or 4000 ho urs.

Therefore, it can be u sed a s it is even in hot areas. Antifreeze is flam mable, so be extremely carefu l not to expose it t o flame or The proportion of anti-freeze to water differs ac cording to the ambi ent temperature For details of the mixing proportions, see "CLE AN INSIDE OF CO OLING SYSTEM (PAGE 4-24)" If the engine over heats, wait for the engine to c ool before adding c oolant. If the coolant level is low, it will cause overheatin g, and will also cau se problems with corrosio n due t o air entering Grease prevent seizure and noises at the joints. equipment is used under heavy-duty conditions.

Always use the recommended grease and Grease is used to prevent seizure and noises a This construction equipment is used under hea vy-duty conditions . Always and follow the change intervals and recommended ambient temperatu res given in this Operatio n and Maintenance Manual. cluded in the maintenance section are nipples for overhaul, so they do not need grease. es stiff after being used for long time, add grease. l of the old grease that is pushed out when greasing.

The nipples not in cluded in the maintenance se ction are nipples fo r overhaul, so th ey do no t need If any part becom es stiff after being used for lon g time, add grease Always wipe off al l of the old grease that is pus hed out when grea Be particularly car eful to wipe off the old grease in places where sa nd or dirt stickin g in the g rease woul d cause wear of the rotatin g parts.