. MAINTENANCE OUTLINE OF SERVICE OUTLINE OF SERVICE HANDLING OIL, FUEL, COOLANT, AND PERFORMING OIL CLINIC 4 - 4 Oil is used in the engine and hydraulic equipment under extremely severe conditions (high temperature, high ssure), and deteriorates with use. Oil pre Alw Op ays use oil that matches the grade and maximum and minimum ambient temperatures recommended i n the eration and Maintenance Manual. Even if the oil is not dirty, always change the oil at the sp ecified interval. Oil corresponds to blood in the human body, always be careful when handling it to prevent any i mpurities (w ater, me The Tak tal particles, dirt, etc.) from getting in. re caused by the entry of such impurities.
get in when storing or adding oil. causes of problems. majority of problems with the machine a e particular care not to let any impurities Ne ver mix oils of different grades or brands. Alw ays add the specified amount of oil. Ha ving too much oil or too little oil are both If th e oil in the work equipment is not clear, there is probably water or air getting into the circuit . In such c ases, ple ase contact your Komatsu distributor. elated filters at the same time. e of the oil periodically to check the condition of the machine. For ontact your Komatsu distributor. y be necessary to shorten the oil change interval. use of the Komatsu oil clinic.
Wh en changing the oil, always replace the r We recommend you have an analysis mad tho se who wish to use this service, please c Wh en using commercially available oil, it ma For this reason, we recommend making full Fuel To prevent the moisture in the air from conde nsing and forming water inside the fuel tank, alway s fill th e fuel tank afte r completing the day's work. d if fuel containing water or dirt is used, it cannot work properly. in when storing or adding fuel. ature in the Operation and Maintenance Manual.
The fuel pump is a precision instrument, an d if fuel containing water or dirt is used, it cannot w ork properly Be extremely careful not to let impurities get Alw ays use the fuel specified for the temper If the fuel is used at temperatures lower th an the specified temperature (particularly at temperatures belo w -15 °C (5°F), the fuel will solidify. If the fuel is used at temperatures higher than the specified temperature, the viscosity will dr op, an d this may result in problems such as a drop in outp ut. Bef ore starting the engine, or when 10 minut es have passed after adding fuel, drain the sedimen t and w ater from the fuel tank.
If th e engine runs out of fuel, or if the filters have been replaced, it is necessary to bleed the air from t he ci rcuit.