Komatsu — ADJUST BUCKET CLEARANCE

. MAINTENANCE MAINTENANCE PROCEDURE ADJUST BUCKET CLEARANCE WARNING (6): Arm (7): Bucket 4 - 34 It is dangerous if the wo rk equipment is mistakenly moved when adjusting the bucket clearance. Set the work equipment in a stable condition, stop the eng ine, then set l ock lever (1) securely to the 1. Set the work equ ipmentin the position shown in the diagram on the right, then s LOCK position ( top the engine and set the lock lever to the L). nd measure the amount of play "a". the 2. Shift O-ring (1) a nd measure the amount of pla Measurement is that all the play c the diagram).

Use a clearance easier if you move the bucket to one side so an be measured at one place (t he right sid e in gauge for easy and accurate measurement. 3. Loosen 4 plate m ounting bolts (2), and loosen The shim is a s without removin 4. Remove shim ( measured above [Example] In the case of p (0.039 in) shim becomes 0.5 mm (0.039 in) and 0. When play "a" is maintenance. lay of 3 mm (0.118 in), remov s and one 0.5 mm (0.020 i e two 1.0 n) shim. P mm lay (0.020 in). For shim (4), two ty pes of 1.0 mm 5 mm (0.020 in) are used. smaller than one shim, do not carry out any bolts (2). 5. Tighten the four If the bolts (2) are for easier tighten too stiff to tighten, pull out pin stopper bolt (5) ing.