. MAINTENANCE MAINTENANCE PROCEDURE REPLACE BUCKET SIDE CUTTER, SHROUD WARNING 4 - 33 I eplacing the bucket sid e cutters and shro Set the w ork equipment in a stable conditi on, stop the engi ne, then set ock leve r (1) securely to the LOCK positio As the lo cking pin is kno cked out with forc e, there is danger that the pin may fly o ut. Check that t here is no one ne ar the machine. Broken p wear safe ieces may fly ty glasses, glo during the replac ves, or other prote ement operation ctive equipment Side Cutter s unting bolts (2), then remove side cutter (1). Replace Loosen mo . Replace the side cu tter, bolts, an d nuts with new parts.
0 N·m (310 to 370 kgf·m, 676.2 lbft) Tightening torque for bo lts: 3040 to 363 2,242.2 to 2, Shroud 1. 1. Place a bar on the he ad of pin (1), hit the bar with a hammer to knock out the pin, th en remove tooth REMARK If it cannot be removed b y this method, f or safety reaso ns, always contact yo ur Komatsu di stributor to hav e the replacem ent carried out . 2. 2. Clean t he mounting face. Fit a new shroud (2) in th e adapter, push in install t pin (1) partia lly by hand, the n lock it with a hammer to he tooth to th e bucket.