Komatsu — BLEEDING AIR FROM HYDRAULIC SYSTEM

. MAINTENANCE MAINTENANCE PROCEDURE 4 - 40 BLEEDING AIR FROM HYDR AULIC SYSTEM For details, see "STARTING ENG INE (PAGE 3-72)". If it is necessary t o refer to the items fo r starting the engine, moving the machine off, steering, or stopping, see the OPERATION se 1. Bleeding air from pump 1) Loosen air bleeder(1) and air bleeder. 2) If the oil does not ooze out hydraulic pump case and with hydraulic oil through Hold the removed hose higher than the oil level in not spill out of the hose. 3) After completing the air ble (1) and install the drain ho 1. Bleeding air from pump NOTICE ill spurt out from bleeder hole (1).

If the drain hose is installed first, oil w If the pump is operated without filling the pump case with hydraulic oil, abnorma l heat will be generated and this may cause an unexpected damage to the pump. 2. Starting engine Start the engine, referring to " Run the engine at low idle for 10 minutes after starting, then start op 3. Bleeding air from cylinders 1) Run the engine at low idle not moved to the end of it 2) Next, operate each cylind 3) Finally, operate each cylin 1) Run the engine at low idle , and extend and retract each cylinder 4 to 5 times, taking care that a cylinder is s stroke. (Stop the cylinder approx.

10 0 mm (3.9 in) short o 2) Next, operate each cylind er 3 to 4 times to the end of its stroke. 3) Finally, operate each cylin der 4 to 5 times to the end of its strok e to completely remo NOTICE If the engine is run at high speed imme diately after startup or a cylinder is pushed up to its stroke end, air t aken inside the cylinder may cause damage to the piston pack ing. 4. Bleeding air from swing motor 1) Run the engine at low idli ng, loosen the S port hose, and check that oil oozes out fro NOTICE Do n ot operate the swing under any c 2) If no oil oozes out, stop the engine, remove the S port hose, and fil l the inside of the mot or case with hydraulic oil.

the air, tighten the S port hose. le and slowly swing at least two times uniformly to the left and right. This will r from the swing circuit. 3) After completely bleeding 4) Run the engine at low id automatically bleed the ai NOTICE motor, the motor bearings may be damaged. If the air is not bled from the swing motor, the motor bearings may be damage W hen replacing the travel motor sa fety valve, please contact your Komatsu di stributor to have it repl aced and to have the air b led.